PZ mortise lock for apartment doors with lockable latch bolt
SKU
KB.7712X
PZ mortise lock for apartment doors with lockable latch bolt
Dimensions:
square spindle:
8 mm steel lever hub
forend width:
20 mm
forend length:
235 mm
distance:
72 mm
backset:
55 mm
lock case height:
154 mm
Product features:
- PZ - prepared for profile cylinder with latch lever (alternating function)
- forend made of stainless steel
- dead bolt and latch bolt made of steel
- with lockable latch
- forend design rounded or square
- 2-turn = 22 mm deadbolt exclusion
- door alignment DIN right or DIN left selectable
- classification according to DIN 18251, class 3
Scope of application:
- suitable for rebated doors with 72 mm distance
- prepared for Euro profile cylinders with latch lever
Determine dimensions correctly:
Backset (in mm): Is the distance from the centre of the lever handle or lock cylinder to the front edge of the forend.
Distance dimension: Is measured from the centre of the lever hub or turning knob to the centre of the cylinder recess (keyhole). This measure is standardized in Germany with the following dimensions:
- 72 mm for interior apartment doors
- 78 mm WC - doors
- 92 mm front doors / apartment doors outside
Square spindel:
- square spindel 8 mm for room doors
- square spindel 9 mm for fire protection doors
- square spindel 10 mm for external doors
Forend width and length: The forend is the front face of the mortise lock which is visible after installation in the door. The design of forend can be rounded or square.
Door alignment:
The DIN direction of the door alignment is also important for the selection of the mortise lock. A distinction is made here between DIN right and DIN left. If the door hinges are on the left-hand side when the observer looks at the closed door, this is a door with a DIN left alignment, if the door hinges are on the right side, this is a DIN right door alignment.
Rebated door:
The most used door is the rebated door. In it, the rebate is a small step at the edge of the door leaf. As a result, the door leaf rests on the frame. A seal on the frame (door frame) provides the necessary sealing and soundproofing.
Non-rebated doors:
Doors without a rebate are called non-rebated doors. Architects often require a harmonious and flush finish between the door leaf and frame. This is achieved by non-rebated door leaves. Due to the flushness of the frame and door leaf, it is an absolute eye-catcher in the room.
Write Your Own Review
